![](https://www.elettronicaprogetti.com/wp-content/uploads/2021/11/Kit-batterie-ricaricabili.png)
Battery Kit and Battery Charger for EP095CM
5 November 2021![](https://www.elettronicaprogetti.com/wp-content/uploads/2021/11/EP096AT-1.png)
Tripod – EP096AT
5 November 2021EP095CR-1/2 Receiver
The EP095CR series receivers can be of different types according to the available outputs:
- EP095CR-8 with 8 outputs, mainly used for Compak
- EP095CR-1 with 1 output, mainly used for Compak
- EP095CR-2 with 2 outputs, mainly used for Skeet
All these receivers are actually Receivers-Transmitters, that is, as soon as they receive the command to release the target, they respond with a confirmation message so that the cost of the clay can be deducted from the chip card possibly inserted in the transmitter. In this way, the cost of the target is charged only and only if the receiver receives the off-hook message correctly.
All the outputs for the throwing machines consist of a free contact of a relay. These units can provide a simple impulse to release the target, or they can provide an impulse of programmable duration for the movement of some special machine which may have some adjustments in position and / or height (tower, candle, …).
With an external antenna this receiver can also be positioned at a great distance from the transmitter.
The configuration to select the number of the range, (i.e. the frequency channel), and to identify the launcher machine to which it is connected, is carried out via an internal dip switch.
The container is made of plastic with IP56 protection degree.
Technical Characteristics
- DIMENSIONS MOD. EP095CR-1/2: 155x114x70 mm
- POWER CONSUMPTION: 12vdc oppure ac / 300mA max.
- WIFI FREQUENCY: 865MHz – 867MHz
- MAXIMUM OUTPUT POWER: 27 dbm
- SENSITIVITY’: -109 dbm
- PROTECTION DEGREE: IP56
- OPERATING TEMPERATURE RANGE: -10°C ÷ +45°C
Application
The EP095CR-1 receivers are normally installed one for each throwing machine and driven via WiFi by the EP095CM multi-function control unit or by the EP095M control unit, as long as it is equipped with an internal WiFi module.
The EP095CR-2 receivers are normally used for Skeet ranges, one is needed for the Pull and one for the Mark and they have two outputs, one for the lamp and one for activating the throwing machine.
They are normally powered by the same power supply as the throwing machine, at 12vdv or 24vdc. If necessary, the external 220vac power supply can be used.
External Antenna
The external antenna supplied with this receiver is approximately 10cm long. with mechanical support and coaxial cable with OSM connector. It allows to gain several db compared to the internal integrated antenna and due to the cable of about 2 meters, it can be installed in the most suitable position for good reception of the wifi signal