Referee’s Box
5 November 2021
Control Unit – EP095M
Approved by ISSF and FITASC, it has been used for the Olympics in: Athens 2004, Beijing 2008, London 2012, Rio 2016 and Tokyo 2020.
The EP095M control unit is completely digital and is designed and built to automatically manage shooting ranges.
Is very well know for being exceptionally fast in allowing target release and for the complete lack of wrong target releases caused by accidental noises.
It is easy to operate and install, has high reliability, allows to use many disciplines.
The EP095M control unit gives the possibility to expand the system over time, by adding a scoreboard or a monitor that will immediately collect and show the results of the round in progress, using a special data connection.
It can also be connected to the control room, where, through other units of the Multi-Pull system, it will be possible to fully manage the Shooting Club for complete automation
Disciplines
The EP095M control unit supports all the official Issf and Fitasc disciplines, including the In-Line mode. It also has many other special disciplines for Trap, Double Trap and Skeet training.
Finally, it has 10 programmable patterns with both Trap and Compak stand rotation and 3 programmable patterns for Skeet. It performs constant control of round, active stand and shooter and has a total target counter.
It automatically records and stores data to be able to restore operation in case of power failure.
Technical Characteristics
- DIMENSIONS of CONSOLLE: 39x29x12 cm
- DIMENSIONS of REFEREE BOX: 20x10x4 cm
- WEIGHT: 2,5 Kg
- DATA INTERFACE: RS485
- OUTPUT FOR TRAPS: 12 VDC 2 A max.
- INPUT VOLTAGE: 110 VAC ÷ 240 VAC / 47 Hz÷63 Hz
- POWER CONSUMPTION: 40 W
- OPERATING TEMPERATURE RANGE: -10°C ÷ +45°C
- PROTECTION FROM LIGHTENING: varistors, transil, gas discharge
Tipical Performances
- Delay between shooter’s call and trap release: 20 milliseconds typical
- Number of traps controlled: 15
- Pause between two consecutive shots: adjustable between 1 and 5 seconds
- Ability to drive 5 lamps for trap or 8 for skeet, for the active microphone
- Ability to drive 2 lamps for skeet, indicating Pull and Mark
- Internal power supply in accordance with UL 1950, IEC 959, EN60590 and VDE 0805
- Complete installation and operation handbook
Chip Card Reader
The EP095M control unit is equipped with a chip card reader that allows to operate directly without operator on the shooting range. The Chip Card system of Multi-Pull system, allows to work very easily, having accurate reports on all rounds performed on the ranges.
Wi-Fi
The EP095M control unit can be integrated with a wireless module that allows to control the throwing machines with wifi instead of cables. This solution can be used very advantageously for compak or sporting, but also to control the unit via a remote terminal (EP095CM) which allows the use of other particular training disciplines.
Accessories – PullT-M
The PullT-M is mounted in place of the referee’s box and is used to manually release the targets in the sporting or compak, either immediately or with delay.
Can be used for competitions or operating with chip card.
Accessorie – Junction Box
The EP096I1 Junction Box is usually mounted near the EP095M unit and houses the numbered terminal blocks to which the cables coming from the microphones and the throwing machines will be connected.
There are two shielded cables, with relative plugs, for connection to the EP095M control unit and for immediate operation and maintenance of the shooting range. For combined ranges, the switching between DTrap / Compak / Skeet is done automatically by changing the discipline on the unit.
Shooting Data Beretta
The EP095M control unit is fully compatible with the Beretta Shooting Data system.
